Soft_TNC

Soft_TNC Reception and Transmission Test

 
 1. Reception Test at APRS
 144.640MHz (9600bps)
 144.660MHz (1200bps)

 
 2. FIREBIRD
 19200bps using HTerm #1
 MixW    ->   OnlineKiss+  ->  HTerm
 (out COM10)  (in  COM11)      (in COM8)
              (out COM7)

 
 3. FIREBIRD
 19200bps using HTerm #2
 Soundmodem_19k2 + Agw_Online_Kiss -> HTerm
                   (out COM7)         (in COM8)

 
 4. DANDE
 23:50-00:09UTC, 25 Dec 2013, Ele 82 S-Z-N
 436.750MHz 9600bps GMSK
 Soundmodem_9k6 + MixW(out COM7) -> KissTerm(in COM8)
 Soundmodem settings as follows below.

 
 5. UWE-3
 01:00-01:13UTC, 26 Dec 2013, Ele 45 NE-E-S
 437.385MHz 9600bps FSK
 Soundmodem_9k6 + MixW
 MixW-Configure-Sound device settings-Samplerate-44100

 
 6. Trouble,
 Soldered again 9600bps connector
 http://www.ne.jp/asahi/hamradio/je9pel/uissagwp.htm#2

 
 7. Reception Test at APRS, 27 Dec 2013
 Upper is 1200bps and Lower is 9600bps.

 
 8. MixW serial port bridge
 MixW(COM10) -> (COM11)OnlineKiss+(COM7) -> (COM8)TunaTerm
 MixW serial port bridge

 
 9. UISS Transmission Test
 I noticed that the same text to appear twice on the window,
 when I send a text once by F5, F6 or F7. Why this happens?
 I removed one port of two ports which I defined the idle
 or incorrect ports in AGWPE.
 UISS setting up with Interface

 
 10. MixW Transmission Retest
 The same text to appear again twice on window.
 When I transmit it, there seems to be a something 
 essential problem. I solved it as described below.
 How to transmit using MixW

 
 11. Transmission operation success!
 Until now, the problem that same text appear twice on the
 window each time the press of a enter_key had occurred.
 I made sure thatToday, 28 Dec 2013, became a display of
 once all after the transmission operation. There was the
 cause to property in the sound settings in "Control Panel".

 
 12. CAPE-2 Software,
 The display of "Invalid" has come out many times in this state
 until now, but it has come to the normal transmission operation.
 Check "Microphone" actively in "Sounds and Audio Device Properties".

 
 
 13. Conceptual Diagram,
 Wrote by PY4ZBZ and edited by JE9PEL

 
 14. UISS Transmission and Reception Success!!
 I was completely successful in the digipeater via
 ISS (International Space Station) using UISS.
 07:54-08:04UTC, 29 Dec 2013, Ele 36 WN-N-E

 
 15. MixW Transmission and Reception Success!!
 I have switched to MixW from UISS of Soft_TNC, and I was success_
 ful again in the transmission and reception of the digital signal.
 The transmission window of MixW does not support APRS format,
 but it support to APRS format as ":JE9PEL   :Hello via ISS" etc.
 http://www.ne.jp/asahi/hamradio/je9pel/aprsform.htm

 
 16. ISS TX/RX using MixW, 01:23-01:33UTC, 31 Dec 2013, Ele 26 W-N-NE
 145.825MHz 1200bps AFSK. From the beginning to the end of this path
 I had a transmission and reception in the APRS format using MixW.
 I confirmed that it has been successfully transferred to findU.com.
 I could communicate with School Contact Utsunomiya Memorial station
 "8N1ISS".  MixW Digipeat All Log (01:23-01:33UTC, 31 Dec 2013)

 
 17. CSSWE using MixW
 10:52-11:05UTC, 31 Dec 2013, Ele 78 SW-Z-NE
 437.349MHz 9600bps GMSK
 MixW(COM7) -> (COM8)CSSWE Decoder

 
 18. CSSWE using Soundmodem_9k6
 11:10-11:23UTC, 1st Jan 2014, Ele 47 SW-N-NE
 437.349MHz 9600bps GMSK
 Soundmodem Settings: "LPF1 Width=8000, LPF2 Width=9500"
 http://www.ne.jp/asahi/hamradio/je9pel/aprs_9k6.htm

 
 19. ISS using UIView32 & UISS
 22:58-23:08UTC, 2 Jan 2014, Ele 50 WS-S-EN
 145.825MHz 1200bps AFSK
 AGWPE: First Run / AgwOnlineKiss: Kiss File Save
 UIV32: APRS SatGate / UISS: Data TX/RX via ISS
 http://www.ne.jp/asahi/hamradio/je9pel/uissui32.htm

 
 20.LitSat-1 #1
 20:23-20:33JST, 4 Apr 2014, Ele 43 SW-N-NE
 145.845MHz 9600bps FSK
 G3RUH_sm V0.16b + Agw_Online_Kiss Ver2.1.2
                         + LiSat-1 Decoder Ver1.83

 
 21.LitSat-1 #2
 19:22-19:32JST, 5 Apr 2014, Ele 60 WS-S-EN
 145.845MHz 9600bps FSK
 MixW V3.0.1 + Online_Kiss_Plus Ver8.5
                         + LiSat-1 Decoder Ver1.83