UISS and UI-View32


I could use to APRS satellite using UISS and UI-View32 with Soundcard (None-TNC).

1) Run AGWPE and UI-View32.
2) Connect APRS.
3) Change "Setup - Comms Setup" in UI-View32 as follows.




4) Then the port of AGWPE pop-up automatically as follows.




5) Run UISS.
6) Sample, TX in UISS -> Sat -> RX in UISS + UI-View32 -> TX to APRS




7) Log in APRS server.




8) SineWave for 1200bps









UIView32-Map & UISS-MapView

In case of Japan Map,

(1) Put the next [JA.inf] file in "UIView32-MAPS" folder.

[JA.inf]------------
45.67.89N, 127.25.17E
30.52.60N, 155.11.57E
JA
---------------------


(2) Put the next [JA.jpg] map in "UIView32-MAPS" folder.

[JA.jpg]



(3) UIVIEW32 - Map - Load A Map - JA
(4) Put the next [JA.ini] in "UISS-Maps" folder.

[JA.ini]---------------------------------
[UI-MapView compatible Scale External Map]
[South_Left=360-lon]
 487.3 
[East_Top=180-lat]
 133.9 
[West_Heigth=lat1-lat2]
 15.0 
[North_Width=long1-long2]
 27.9 
[Name]
JA

UI-View original coordinates
127.25.17E,45.67.89N
155.11.57E,30.52.60N
------------------------------------------

Then,
 487.3 = 360 + 127.3           (Note "+" as East longitude)
 133.9 = 180 - 45.68 - 0.42    (0.42 is Revise value)
 15.0 = 45.68 - 30.53 - 0.15   (0.15 is Revise value)
 27.9 = 155.12 - 127.25 + 0.03 (0.03 is Revise value)


(5) Put the above [JA.jpg] map in "UISS-Maps" folder.
(6) UISS - Modules - UISS_MapView - Maps
(7) Select this [JA.jpg] map.
(8) UISS - Modules - UISS_MapView - Options - SetUp
(9) Don't check at "Never rescale" because this [JA.jpg] is a large size.





Japan Map for UISS: japan_je9pel  (in progress)
Japan Map for UISS: japanggl-uiss (in progress)

Japan Map for UI-View32: japanggl-uiv32 (in progress)
Japan Map for UI-View32: japan-pl (completed)


Back to Top
Back to UISS index
Back to Home Page