WOODPECKER STUDIO(top) > Papercraft > How to make the animal card
* The tools to prepare ![]() *Some colors of cardboard. --The one for the animal is a little thin paper. --The one for the mount is a little thick paper. --The paper which a message is written in. *Punch *Adhesive *Scissors *Cutter and cutter mat *Stapler *Ball-point pen and ruler |
* A procedure for making the card. 1. The paper pattern Print the paper pattern on the paper of A4 size. Cut the printed paper into four sheets. 2. Preparation to cut ![]() The paper pattern is folded from center line, too. The paper pattern is put on the cardboard, and 2-3 places are fixed with the stapler. 3. Fold line Trace with a ball-point pen from over of the paper pattern, and a fold line is given. Trace with both sides of the right and left as well. 4. Eyes and nostrils The hole of the eyes are made. A hole is made with a punch, or it is clipped by using the cutter. 5. Cut ![]() First, clip the part of the jaw with the scissors. The line of the head-tail cuts either from the one which is easy to cut by you. Don't care even if it deviates a little. 6. Fold ![]() "The overlap width" of a foot to put on the mount is folded, too. 7. Mount The animal is pasted on the mount with adhesive. The mount paper is folded at the side. The position where an animal doesn't protrude is ascertained when it tried to leave an animal in the mount and a mount was folded. A leg is put first, and the fold line of the mount is made to pile up with the line on the back viewed from the top, and one of the feet has already been put, too. 8. Message paper ![]() Make a slit in the paper about 2mm, and put with the slit of the animal's hand. 9. Completed ![]() The card which the animal who has a card from the card jumps into. Could it be done well? (Attention!) WOODPECKER STUDIO possesses the copyright of the design of the animal card and the paper pattern. Commercial use is prohibited. Private use is permitted. |