AGWPE

AGWPE TCP/IP settings

1. Download AGWPE and "TCPIP Over Radio Driver".
   http://www.sv2agw.com/downloads/default.htm

   


2. Extract "agwpe.zip" and install it.
   http://www.soundcardpacket.org/

3. Extract "tcpip.zip" and extract "tcpipXP.zip" in it.

4. Install "TCPIP Over Radio XP"
   http://www.sv2agw.com/ham/tcpip_winxp.htm

   

   1          2          3          4          5          6          7
         
   8          9          10         11         12         13         14
         


5. Run AGWPE and click an icon. And click "TCPIP Over Padio SetUp".
   
   


6. Setup "TCPIP Driver" in AGWPE as follows.

   

    NOTE: It will be shown the indication of (1) when you push OK
       button before setting of the installation of TCPIP Driver
       which mentioned above are over. This indication disappear
       when you press four times of OK button. However, it will
       be shown the indication of (2) when you start AGWPE on the
       next time. AWPE returns to the initial state when you check
       "Thank's NO TCPIP" in (3), then please finish the setting
       of 1.~5. mentioned above from the beginning.

       (1)                 (2)                 (3)
         


7. "AGWPE TCP/IP settings" completely.


8. [Supplement1]
   http://www.sv2agw.com/ham/default.htm

   


9. Download "XI-V Agw Decoder"
   http://www.info.nara-k.ac.jp/~asai/download/

   


10.[Supplement2]
   "Soundmodem --> XI-V AGW Decoder"

   
                                                        (Click to enlarge)

11.[Supplement3]
   Soundmodem --> XI-V AGW Decoder --> LoopBack(COM7) --> KissTerm(COM8)

   
                                                        (Click to enlarge)

12.[Supplement4]
   AGWPE LoopBack
   http://www.ne.jp/asahi/hamradio/je9pel/snd2uiss.htm#loopback