UISS

How to SatGate using UISS only

In case of GO-32:





You can SatGate to APRS using a new 'UISS-SatGate 1.0' program, not UI-View32.
Note: It works only with UISS Pro-Edition


(1) Firstly, setup AGWPE auto_run in
    'UISS - Setup - Extra - Run Application on Start-Up'.

(2) Download 'UISS-SatGate Ver1.0' on http://users.belgacom.net/hamradio/uissmodules.htm
    and extract it in the same folder of UISS.

(3) You can see 'UISS-SatGate' in Modeles tab of UISS.

(4) Press 'Connect' button in 'APRS Host Server'.

(5) Then you can see an access log on the findu.com web. 

(6) See protocol about 'EAX25' that is seen in the bottom jpg file in this page.
















http://satgate.aprsca.net:14501/




http://www1.findu.com/cgi-bin/pcsat.cgi?absolute=1




UISS Auto Run Application

In 'UISS - Setup - UISS - Extra - Run Application on Start-Up' we appoint
a folder with AGWPE and check into 'Auto Run Application'. However, in fact,
the message which there cannot be a port of AGWPE at the time of a setup of
next UISS appears only in this, and UISS does not run normally.

When even if this message is given, run once UISS in the state that there
is not AGWPE, and click an icon of AGWPE appearing in the Windows screen
lower right. Because a screen of 'AGWPE - Properties - Select Radio Port'
become blanks, we setup again here a port of AGWPE which I performed before
some other time . Then AGWPE run automatically from a setup of next UISS.

A lot of modules are prepared for UISS, and 'UISS_SatGate' of those is the very
convenient module which can cooperate with APRS, but there is a correspondence
deficiency to indication of an APRS server side in the case of the EAX25 signal
reception of AO-51. I am finished with a report to both authors of UISS and
UISS_SatGate, but the improvement does not go ahead through this matter.


UISS system update
http://www.ne.jp/asahi/hamradio/je9pel/uisssatu.htm