Tyrrell P34

1 2 3 4

-Let's make a seat.-

Parts No.14,15,16,s1,s2,s3,s4,s5 is cut.
-Let's make a seat.-

It is assembled as the left photograph.
-Let's make a seat.-

It is installed as the left photograph.
-Let's make a Front cowl.-

Part It is cut off after NO.17 is piled up.
-Let's make a Front cowl.-

A curve is given as the left photograph.
-Let's make a Front cowl.-

It is assembled as the left photograph.

Let's make it so that a bottom part may become a flat as much as possible.
-Let's make a Side cowl.-

Parts NO. 18,19,20,21,22,23 is cut as the figure.

-Let's make a Side cowl.-

It is assembled as the left photograph.
-Cowl is installed.-

Cowl is installed in accordance with the line.
-Let's make a front section.-

Parts NO.24,25,26 is cut as the figure.
-Let's make a front section.-

It is assembled as the left photograph.
-Let's make a front section.-

It is installed as the left photograph.
-Let's make a front section.-

Parts NO.27,28 is cut as the figure.
-Let's make a front section.-

It is assembled as the left photograph.
-Let's make a front section.-

It is installed as the left photograph.
-Let's make Upper section.-

Parts NO.29,30 is cut as the figure.

Because it was difficult, a spare was added.
-Let's make Upper section.-

It is assembled as the left photograph.
-Let's make Upper section.-

It is installed as the left photograph.
-Let's make Upper section.-

It is assembled as the left photograph.
-Let's make Upper section.-

It is assembled as the left photograph.
-Let's make Upper section.-

It is installed as the left photograph.
-Let's make Upper section.-

It is installed as the left photograph.








STEP 3

1 2 3 4