Tyrrell P34

1 2 3 4

-How to make Monocoque-

Parts NO. 1,2,3 is cut as the figure.
A red line is to do a clipping.
-How to make Monocoque-

Parts The assembling conditions of NO. 1,2,3
-How to make Monocoque-

Parts The assembling conditions of NO. 1,2,3
-How to make Monocoque-

Part NO. 4 is cut as the figure.
-How to make Monocoque-

Part The assembling conditions of NO. 4
-How to make Monocoque-

It is assembled as the left photograph.
-Let's make Under panel.-

Part NO.5 is clipped, and bent, and the front is glued. A side panel part is folded down.
-Let's make Under panel.-

It is assembled as the left photograph.
-Let's make Side panel.-

It is assembled as the left photograph.
Parts NO.6,7
-Let's make Side panel.-

It is assembled as the left photograph.
-Let's make a rear section-.

Part NO.8 is cut.
-Let's make a rear section-.

It is assembled as the left photograph.
-Let's make a rear section-.

It is installed as the left photograph.
-Let's make Front suspention.-

parts NO. 9,10 is cut and assembled as the photograph.
-Let's make Front suspention.-

It is installed as the left photograph.
Let's make Front section.

It is assembled as the left photograph.
Parts NO.11,12,13
Let's make Front section.

It is installed as the left photograph.
Parts NO.11,12,13
Let's make Front section.

It is installed as the left photograph.
Parts NO.11,12,13








STEP 2

1 2 3 4